Part 1 - Gold ring reclaw
DaDo Online LWA - Module 5 - Reclawing & retipping
•
7m 59s
Timeline
Protecting the Stone:
For beginners, covering the stone with blue tack is suggested for protection \[00:35].
However, with more confidence, this may not be necessary \[00:45].
Preparing the Wire:
A recess is cut into the claw, and a flattened wire is fitted flush onto it \[01:43].
Attaching the Claw:
Using the lowest power setting, the wire is attached to the existing claw
[02:04].
The power is adjusted as needed to achieve a smooth melt \[02:52].
Shaping the Claw:
The claw is turned down, and work is done on the sides [03:27].
A blade is used as a guard [04:31].
Removing Excess Claw:
Pliers and a saw frame are used to remove the old claw [05:06].
The new claw is then pushed down [05:23].
Finishing Touches: The claw is rounded off and shaped to match the others [06:48].
A laser is used to address any recesses, with infill added for strength [05:53].
Final Result:
Once polished, the replaced claw should be indistinguishable from the others [07:35].
Up Next in DaDo Online LWA - Module 5 - Reclawing & retipping
-
Part 2 - Silver ring reclaw
Timeline:
First, a piece of wire is prepared and flattened to fit into the ring's recess \[00:30].
The laser's power is adjusted to ensure it interacts correctly with the ring \[00:43].
The claw is attached to the setting by aiming the laser at the claw and pulling it onto the setting \[01:12]...
-
Part 3 - Silver ring retip
Finding the Correct Laser Power:
First, find the appropriate power level on the laser for the material being worked on. [00:45]Adjusting the Power:
Once the initial power level is found, slightly reduce it to ensure controlled application. [01:02]Adding Silver Material:
Apply silver to the to...
