Part 2 - Gold cross
The Complete DaDo Online LWA: Module 1-7
•
2m 31s
Power:
Start by setting the laser power to zero [00:54].
Gradually increase the power until you see action on the cross itself [01:02]
First Shot:
Aim the laser at a spot away from the area needing repair to test the action [01:02].
Infill gold wire:
Introduce gold to the area that needs to be filled [01:11]
Use the laser to infill the crease with the added gold [01:25].
Keep applying the laser and adding gold until the level is above the original surface [01:51].
Sand and file:
Once the area is filled, sand and file it back to match the original level [02:01]
Up Next in The Complete DaDo Online LWA: Module 1-7
-
Introduction to Module 4
Join Paul as he guides you through the process of rejoining and resizing gold and silver rings using infilling and laser wire with the DaDo 2.0 laser welder . You'll learn how to create smooth, durable joins and achieve a professional finish with ease and learn why a laser can be better than a fl...
-
Part 1 - Gold ring join
Timeline
First, create a V-cut with an angle on the ring \[00:30].
The V should be knife-edged \[00:42].Start at a low power setting and gradually increase it until you achieve the desired action \[00:50].
If it sounds "splatty", it's too hot, so decrease the power \[01:12].Tack the ring to ...
-
Part 2 - Gold ring resize
Initial Attachment: Begin by attaching one side of the new gold section to the existing ring shank using a low power setting on the laser welder [00:28].
Second Side Attachment: Join the other side of the new section to the shank, ensuring a close and even fit [00:56].
Use pliers to adjust and ...
