Part 2 - Gold trace chain
The Complete DaDo Online LWA: Module 1-7
•
2m 14s
Timeline
Initial settings:
Begin with a low power setting on the laser [00:46].
First shot:
Direct the initial laser shot onto the body of the link, avoiding the joint [01:00].
Adjust power:
Fine-tune the power setting based on the action observed. If it's too strong, reduce it slightly [01:06].
Squeeze the link:
Gently squeeze the link to ensure the joint is flush and closed [01:21].
Weld the joint:
Hold the link gently and apply the laser to the joint [01:28].
Finishing touches:
Reduce the power setting slightly for cleaning up and finishing the job [01:43].
You might also increase the spot size at this stage. [01:43]
Up Next in The Complete DaDo Online LWA: Module 1-7
-
Part 3 - Silver figaro chain
Timeline
Flush join:
First, ensure the link is as flush as possible [00:25].White/ Blu tack:
Then, push the chain into white tack to be hands-free [00:46].Black marker pen:
Mark it up with a black marker pen to help it flush nicely [01:03].Power:
Start at the lowest power level and work ... -
Part 4 - Silver curb chain
Timeline
Flush link:
First, ensure the link is flush [00:27].Blu tack:
Use blue tack and your left thumb to secure the chain, exposing the link [00:40].Power:
Start with the laser at the lowest power setting [01:04].
Increase the power in increments [01:09].Firing the laser:
Fire the laser... -
Introduction to Module 3
Infilling using laser wire - Infilling with a laser welder and wire allows jewellers to seamlessly fill gaps, repair cracks, or restore worn areas with precision without damaging delicate details.
